Kenwood DPX-6020 - Manual (Page 44)

The following messages are displayed when certain problems are occurring in your system. Take the recommended
actions.
No disc magazine has been loaded in the changer. The disc magazine is not completely loaded.
Load the disc magazine properly. ]
EJECT
No disc has been loaded in the disc magazine.
Load a disc into the disc magazine. ]
No Disc
— 44 —
English
Troubleshooting Guide
External Disc Control Mode
The computer chip in the unit is not functioning normally. Press the reset button on the unit (see p. 3).
The disc control mode cannot
be selected. No wire has been connected to the disc changer input
terminal on the unit. Connect the wire to the disc changer input terminal on the
unit.
The specified disc does not
play, but another one plays
instead. The specified CD is quite dirty. Clean the CD.
The CD is upside-down. Load the CD with the labeled side up.
The disc is loaded in a different slot from that specified. Eject the disc magazine and check the number for the
specified disc.
The disc is severely scratched. Try another disc instead.
The sound skips. Something is touching the disc changer. Remove whatever is touching it.
The CD is scratched or dirty. If skipping happens at the same place when the car is
stopped, something with the CD is wrong. Clean the CD.
The display shows that the
changer is being played, but no
sound can be heard.
The specified track will not
play. Random play or magazine random play has been selected. Turn off random play or magazine random play (see p. 20).
SOLUTION POSSIBLE CAUSE PROBLEM
If the following situations, consult your nearest service center:
• Even though the disc changer is connected, the Disc Changer Mode is not on, with "AUX Mode" showing in the display during the Changer
Mode.
• Even though no device (KCA-S210A, CA-C1AX, KDC-CPS87, KDC-CX87, KDC-CPS85, KDC-CX85, KDC-CPS82 or KDC-CX82) is connected, "AUX
Mode" is displayed when switching modes.
DPX-6020_K_U.S 01.12.25 1:57 PM Page 44