Kustom HV65 - Manual (Page 9)

9
HV™ 65
Specifications
Mode l HV 65 Hybrid Tube Guitar Amplifier
Tube s Preamp 1-12AX7
Output Pow e r 65 W atts, RMS 8 Ohms @ 5% THD
Spe a ke rs 1 X 12 Inch Celestion G12P80
Input Im pe da nce Single Input 100 K ohms
Hum & Noise -60 dBV Residual Noise, all level controls 0% (minimum)
Syste m Ga in 45 dBV Rhythm Channel Nominal gain, Volume @ 5
65 dBV Rhythm Channel Maximum gain, Volume @ 10
50 dBV Lead Channel Nominal gain, Volume @ 5
70 dBV Lead Channel Maximum gain, Volume @ 10
10 dBV Maximum gain of footswitchable Volume Boost
10 dBV Gain increase at 1 kHz when Gain Boost is pressed
6 dBV Gain increase at 1 kHz when Overdrive is pressed
27 ~ 37 dBV Power amp gain (Effects Return to Speaker, depending on Boost)
Nominal Signal to Noise 70 dBV Rhythm Channel, with Volume half and Master Maximum, Boost on 10
0.33 VRMS (-10 dBV) Levels w/Boost on 10 to reach full power output
1 VRMS (0 dBV) Levels w/Boost on 0 to reach full power output
Footswitchable Boost Master Volume Boost Adjustable from 0 to +10dB boost AFTER the Effects Loop
XLR Direct Output After power amp with speaker emulation
Digital Effects
Use KACFS101M (sold separately) or standard momentary Footswitch with mono cable for Tap.
USA/Canada 120VAC/60Hz, 120W nominal
Europe 230VAC/50Hz, 120W nominal
UK 230VAC/50Hz, 120W nominal
Australia 240VAC/50Hz, 120W nominal
Japan 100VAC/50-60Hz, 120W nominal
mm/kg 465 (Height) x 535 (W idth) x 300 (Depth), 16.8kg
Inches/Pounds 18 (Height) x 21 (W idth) x 11 3/4 (Depth), 36.7 lbs
Uses a standard stereo shielded cable, but can use mono cable for emergency limited functions.
Dimensions
Power Requirements
Footswitch
All measurements taken with
1 KHz input signal, Tone
controls flat, Boost volume
control at 0 Unless stated
otherwise, Effects turned off.
Measured at speaker jack
with 8 ohm load.
Effects Loop
Use KACFS301 (sold separately) to Select Rhythm/Lead, Boost, Effects On/Off
24 bit DSP module, 16 effects w/programmable tap-toggle switch.