Kodak 4800 User Manual
Page 70
Troubleshooting E-7
Reference Guide
Run the jet status plot as described in the Quick Start Guide. If sections of the print are
missing, add the affected jets to the compensation list. Replace the cartridge if necessary.
Ink spills on the flex cable
Flex cable refers to the copper contacts on the carriage where the cartridge seats. Clean
the flex cable gently with a cotton swab moistened with water. Do not use acetone or
any other harsh cleaner as this may cause damage to the flex cable.
Printer settings are lost when printer is turned off or rebooted
Be sure to save your printer settings to a User number. (See "Saving User Settings" in
Chapter 2.) When you are ready to print, select the User number that you saved.
What if I need a firmware upgrade?
You can download firmware upgrades from KODAK PROFESSIONAL’s Large Format
Print Quality
Many of the print quality concerns can be resolved by priming, cleaning, and calibrating
the cartridges. When this is the case, “Prime, clean, calibrate, or replace” is indicated
with other solutions. Refer to the following chapters for details:
Prime - see Quick Start Guide
Clean - see Maintenance Guide
Calibrate - see Quick Start Guide
Replace - see Maintenance Guide
No print appears
Check that tape has been removed from the printhead of the cartridge.
White lines or large gaps on print or portions of characters missing
Prime, clean, calibrate, or replace cartridges.
Check if the ink reservoir is empty. Refill if necessary.
Make sure the media feeds freely.