Kathy Ireland Home WLTL23180 - Manual (Page 5)

5
32
26
22
6. Remove the backing from the Adhesive Clip (22). Press
the Adhesive Clip onto the Frame (32) in the indicated
location. Press the Allen Wrench (26) into the Adhesive
Clip.
7. Make sure that all parts are tightened before you use the treadmill. To protect the floor or carpet, place a
mat under the treadmill.
4
4. Insert the Reed Switch (7) into the Reed Switch Clip
(14). Attach the Reed Switch Clip to the Frame (32) with
the Clip Screw (13). Next, carefully pull any slack in the
Reed Switch Wire out of the left Handrail (6).
Refer to the inset drawing. Locate the Magnet (15) on
the left Flywheel (12). Turn the Flywheel until the
Magnet is aligned with the Reed Switch (7). Make sure
that there is a 1/8Ó gap between the Magnet and the
Reed Switch. If necessary, loosen the Clip Screw (13)
and move the Reed Switch slightly. Retighten the Clip
Screw. 13
6
14
7
32
6
1
33
5. The Console (1) requires two "AA" batteries (not includ-
ed). Alkaline batteries are recommended. Open the
Battery Cover (33) by sliding it upward. Insert two batter-
ies into the battery clip, making sure that the negative
(Ð) ends of the batteries are touching the springs in
the battery clip. Insert the battery clip back into the
Console and slide the Battery Cover (33) back into
place.
5
Batteries
Battery Clip
15
12
13
7
1/8Ó
Top View