Kompernass LERVIA KH 94 - Manual (Page 9)

7
0 5. Set the telescopic tube into your required position by pressing the telescopic adjuster $ and pulling the bottom tube.
0 6. Pull the plug ` /mains cable out as far as you require.
0 7. Press the foot switch ON/OFF 1 to switch the appliance on.
0 8. All further settings can be made directly and easily using the handle/remote control ! (see section »Remote control from handle«).
0 9. For short pauses in work use the AUTO-POWER ON/OFF feature (automatic on/off switch). To do this, place the telescopic tube into the parking rail 5 –
the appliance switches off and goes into stand-by mode. When you take the tube out of the parking rail - the appliance switches on again. You can then set the
suction power you require as described below.
10. Press the foot switch ON/OFF 1 again to switch the appliance off.
11. After you have finished vacuuming always pull the plug ` out of the mains socket.
12. Rewind the mains cable by actuating the foot switch 3 for the cable tidy on the vacuum cleaner.
13. You can remove the hose & from the vacuum cleaner before storing. To take the hose out of the hose socket, press both buttons * at the end of the hose.
Remote control from handle
The handle/remote control ! allows you to operate the vacuum cleaner conveniently, without bending down.
• Pull the mains cable out as far as you require and insert the plug ` into the mains socket.
• Press the foot switch ON/OFF 1 on the vacuum cleaner to switch it on.
• All further vacuuming functions can now be controlled from the handle:
[AUTO]
= automatic adjustment of the suction power; ensures that the suction power is automatically set to suit the type and structure of the surface
to be cleaned.
[–] = to reduce suction power manually
[+] = to increase suction power manually
[Plug] = Standby feature; for a short pause in vacuuming without turning the appliance off completely. To reactivate - press the button again.
4 suction power settings
The 4 suction power settings allow you to set the optimum suction power for the surface being cleaned (e.g. tiles, parquet) or to suit the amount of dirt present.
As you reduce the power in the lower settings you also reduce the noise level, which allows you to vacuum quietly, say when your baby is sleeping or to suit
the particular time of day or night.
Supplied accessories
• Floor tool/brush %
Press the changeover switch ^ to set the floor brush for use on floors and smooth or flat surfaces. This setting is for cleaning PVC, floor-boards, marble,
sandstone, parquet etc. Place the changeover switch ^ into its original position again when you wish to use the floor tool % for carpets or soft surfaces.
• Crevice tool ቢ
Use the crevice tool to reach places that are narrow or difficult to access, such as around curtain rails, along skirting boards, in recesses, corners and
narrow openings.
• Textile tool ባ
Manual_GB 23.05.2003 11:01 Uhr Seite 7