Kompernass SFS 150 A1 - Manual (Page 6)

- 4 -
Utilisation
Sealing the film
Attention:
For sealing use only films rated HDPE (High Density
PolyEthylene) or LDPE (Low Density PolyEthylene).
The film thickness must be 30 - 50 μ (0.03 - 0.05
mm). Otherwise, the sealing seam will not be tight
and the appliance could be damaged. You will
recognise films of this type by the information on the
packaging.
The quality of the seal joint varies depending on the
type and strength of the film.
Attention:
Do not heat the supplied film, for example in a water-
bath or similar. It is construed for temperatures of
a maximum of 60°C.
➩
Fold the appliance cover u up.
➩
Pull out as much film as is required for the task
at hand.
➩
Then close the appliance cover u .
➩
Firmly press the appliance cover u down.
Note:
The bag opening must sit smoothly on the sealing
wire
r and on the cutting wire e . Otherwise, the
sealing and cutting will not function properly.
➩
Press and hold the Seal/Cut button y with
both hands until the control lamp i lights up.
Hold the Seal/Cut button y pressed down
until the control lamp down i goes out.
Note:
To achieve the best results, press the Seal/Cut but-
ton
y down continuously, applying an even pres-
sure and using both hands.
IB_SFS_150_A1_46614_LB6 05.03.2010 11:31 Uhr Seite 4