Kodak EASYSHARE C1013 - Manual (Page 46)

40 www.kodak.com/go/support
Troubleshooting
In Review mode, a
blue or black
screen is displayed
instead of a
picture. ■ Transfer the picture to the computer (see page 35 ).
■ Take another picture. If problem continues, try internal memory and/or
another memory card.
Shutter button
does not work. ■ Turn on the camera (see page 2 ).
■ Transfer pictures to the computer (see page 35 ), delete pictures from
the camera (see page 14 ), switch image storage locations ( see
page 27 ), or insert a card with available memory (see page 3 ).
Picture is too light. ■ Move so there is at least 2 ft (0.6 m) between the camera and the
subject.
■ Decrease Exposure Compensation (see page 29 ).
Picture is not clear. ■ Clean the lens ( see page 48 ).
■ Make sure your camera is not in Close-up mode.
■ Move so there is at least 2 ft (0.6 m) between the camera and the
subject.
■ Place the camera on a flat, steady surface or use a tripod.
Picture is too dark. ■ Turn on the flash (see page 7 ).
■ Move so there is no more than 10.5 ft (3.2 m) in wide angle and
5.9 ft (1.8 m) in telephoto between the camera and the subject.
■ Use Fill flash ( see page 7 ) or change your position so light is not
behind the subject.
■ Increase Exposure Compensation (see page 29 ).
Camera does not
recognize
SD/SDHC card. ■ Purchase a certified SD or SDHC card.
■ Insert a card into the slot, then push to seat (see page 3 ).
Camera freezes up
when a card is
inserted or
removed. ■ Turn the camera off, then back on. Make sure the camera is turned off
before inserting or removing a card.
If... Try one or more of the following