Kompernass KH 1410 - Manual (Page 8)

- 6 -
Lamellen filter
To take the lamellen filter out, proceed as follows:
Attention!
Before taking the filter out, remove the plug 9
from the power socket. The appliance could be
inadvertantly switched on.
1. Remove and empty the dust collector t as
described in the chapter „Emptying the dust
collector“.
2. Take off the cover Ầ of the dust collector t
with the lamellen filter ấ and the filter grill Ấ .
3. Turn the filter grill Ấ , until it can be removed.
4. Turn the lamellen filter ấ , until it can be
removed.
Should the lamellen filter ấ and the filter grill Ấ be
heavily soiled, rinse them both thoroughly under
clean running water.
Attention!
Do not use a brush for cleaning! The lamellen filter
ấ could be damaged!
Afterwards allow the lamellen filter ấ and the filter
grill Ấ to dry out (ca. 15 hours at room temperature).
Replace the lamellen filter ấ and the filter grill Ấ
only when they are both completely dry.
5. To reassemble the dust collector t proceed in
the opposite sequence.
Motor protection filter
Attention!
Before taking the filter out, remove the plug 9 from
the power socket.
1. Open the housing lid q .
2. Take out the motor protection filter ầ and re-
move the vacuumed in particles from the filter
and the grill lying behind it.
Notice:
Should the motor protection filter ầ be heavily
soiled, rinse it thoroughly under clean running
water. Afterwards allow it to dry out ( ca. 15 hours
at room temperature). Replace it only when it is
completely dry.
3. Replace the motor protection filter ầ .
4. Close the housing lid q .
IB_KH1410_E2687_GB_LB4+5 21.01.2008 10:23 Uhr Seite 6