Life Fitness C9I EN - Manual (Page 6)

1. Locate the BOTTOM POLAR COVER (#6). Position the cover
as shown with the notch of the center hole facing downward.
Slide the BOTTOM POLAR COVER down over the UPPER
CONSOLE SUPPORT TUBE (A) until it rests against the
FRONT TUBE EXTENSION (B).
2. Position the HANDLEBAR (#11) as shown near the UPPER
CONSOLE SUPPORT TUBE (A).
3. Models 95Ci and C9i Only
Connect the 2-PIN HEART RATE CONNECTOR (2P) leading
from the HANDLEBAR (#11) center to the 2-PIN HEART
RATE CONNECTOR (2P) leading from the UPPER
CONSOLE SUPPORT TUBE (A).
4. Carefully slide the HANDLEBAR MOUNTING FLANGES (C)
into the UPPER CONSOLE SUPPORT TUBE (A).
NOTE: BE CAREFUL NOT TO PINCH THE HEART RATE
CABLE WHEN INSERTING THE HANDLEBAR FLANGES
(C) INTO THE UPPER CONSOLE SUPPORT TUBE (A).
5. Secure the HANDLEBAR (#11) to the UPPER CONSOLE
SUPPORT TUBE (A) using four MOUNTING BOLTS (#1).
Tighten the SCREWS to 15-20 ft. lbs.
6. Models 95Ci, 93C, C9i, and C7 Only
Insert the POLAR RECEIVER (#13) into the polar receiver
receptacle located at the center of the UPPER CONSOLE
SUPPORT TUBE (A). Slide the POLAR RECEIVER SLEEVE
(#14) over the POLAR RECEIVER covering the entire POLAR
RECEIVER.
7. Locate the TOP POLAR COVER (#5). Slide the BOTTOM
POLAR COVER (#6) upward toward the HANDLEBAR (#11)
until it contacts the HANDLEBAR. Position the TOP POLAR
COVER over the POLAR RECEIVER (#13) and HANDLEBAR
and align it to the BOTTOM POLAR COVER. Secure the TOP
POLAR COVER to the BOTTOM POLAR COVER using four
PHILLIPS SCREWS (#2) as shown.
8. Models 95Ci, 93C, and C9i Only
Align the ACCESSORY TRAY (#3) to the bottom of the
DISPLAY CONSOLE (#4) as shown. Secure the
ACCESSORY TRAY to the DISPLAY CONSOLE using four
PHILLIPS SCREWS (#2).
9. Models 90C and C7 Only
Remove the BATTERY DOOR located on the back of the
DISPLAY CONSOLE (#4). Locate the supplied 9-VOLT
BATTERY (#12) and connect it to the battery lead. Place the
BATTERY into the DISPLAY CONSOLE and replace the
BATTERY DOOR.
10. Position the DISPLAY CONSOLE (#4) above the MOUNTING
BRACKET (D) as shown. Attach all CONNECTORS (E)
leading from the DISPLAY CONSOLE MOUNTING BRACKET
to the corresponding CONNECTORS located on the back of
the DISPLAY CONSOLE.
11. Attach the DISPLAY CONSOLE (#4) to the DISPLAY
CONSOLE MOUNTING BRACKET (D) using four SCREWS
(#2).
NOTE: BE CAREFUL NOT TO PINCH ANY CABLES WHEN
SECURING THE DISPLAY CONSOLE (#4) TO THE
DISPLAY CONSOLE MOUNTING BRACKET (D).
Tighten the screws securely.
2
3
4
2
14
6
C
5
13
A
2P
2P
D
E
11
B
1
1
12
2
7
15
8
F