LSI MegaRAID Express 500 User Manual
Megaraid, Express 500 hardware guide
Advertising
Table of contents
Document Outline
- 1 Overview
- 2 Introduction to RAID
- 3 RAID Levels
- 4 Features
- 5 Configuring MegaRAID Express 500
- 6 Hardware Installation
- Checklist
- Installation Steps
- Step 1 Unpack
- Step 2 Power Down
- Step 3 Configure Motherboard
- Step 4 Install Cache Memory
- Step 5 Set Jumpers
- Step 6 Set Termination
- Step 7 Install MegaRAID Express 500
- Step 8 Connect SCSI Cables
- Step 9 Set Target IDs
- Step 10 Power Up
- Step 11 Run MegaRAID BIOS Setup
- Step 12 Install the Operating System Driver
- Summary
- 7 Cluster Installation and Configuration
- Software Requirements
- Hardware Requirements
- Installation and Configuration
- Driver Installation Instructions under Microsoft Windows 2000 Advanced Server
- Network Requirements
- Shared Disk Requirements
- Cluster Installation
- Installing the Windows 2000 Operating System
- Setting Up Networks
- Configuring the Cluster Node Network Adapter
- Configuring the Public Network Adapter
- Verifying Connectivity and Name Resolution
- Verifying Domain Membership
- Setting Up a Cluster User Account
- Setting Up Shared Disks
- Configuring Shared Disks
- Assigning Drive Letters
- Verifying Disk Access and Functionality
- Cluster Service Software Installation
- Configuring Cluster Disks
- Validating the Cluster Installation
- Configuring the Second Node
- Verify Installation
- SCSI Drive Installations
- Configuring the SCSI Devices
- Terminating the Shared SCSI Bus
- 8 Troubleshooting
- A SCSI Cables and Connectors
- B Audible Warnings
- C Cluster Configuration with a Crossover Cable
- Glossary
- Index