Lucent Technologies Voice Terminal 8410 - Manual (Page 7)

7
.
NOTE: You can use this feature only if the Reset
Spkr label appears under the button.
To adjust the speakerphone to the surrounding
room acoustics
1 While on-hook, press and then press
.
•
You hear a series of tones.
To select a personalized ring
1 If your 8410 has a button, press and
then press ;
if your 8410 has a button, press .
•
Current ringing pattern plays.
2 To cycle through all eight ring patterns:
if your 8410 has a button, continue to
press (and then release) to hear each
subsequent pattern;
if your 8410 has a
button, continue to
press (and then release) to hear each new
pattern.
NOTE: If your 8410 has a display, you can also press
or to cycle through the eight ringing
patterns.
3 To set your selected ringing pattern:
if your 8410 has a button, press when
you hear the desired ringing pattern;
if your 8410 has a
button, do not press
anymore. You will hear the selected ringing
pattern two more times, and then it will be
automatically saved.
•
You hear confirmation tone.
To adjust ringer volume if necessary (speaker is
not active)
1 To raise the volume, press the right half of the
Volume control button labeled ; to lower the
volume, press the left half of the Volume control
button labeled
.
RESET SPEAKERPHONE
SELECT RING (and RINGER VOLUME)
Speaker
Shift
Speaker
Shift Shift
Hold
Ring Ring
Shift
Hold
Ring
Ring
Next Prev
Shift Shift
Ring
Ring
8410.qref.def3 Page 7 Monday, August 17, 1998 9:09 AM