LG 206-4071P - Manual (Page 2)

206-4071
P A G E 2
Installer Overview
This is the commercial mode setup guide only. For all other
information refer to the separately-supplied TV Owner’s Manual
(Users guide).
Operating Installer Menu
To set up the controls for the TV you will need to know how to enter
the TV Installer menu and make changes to the default values as
required. If necessary, familiarize yourself with the TV Installer menu
and how to make and save changes in the menu.
LG Installer Remote
You will need an LG Installer remote control similar to the one
shown to the right. The installer remote must have a “Source” but-
ton or its equivalent. The remote shown in this manual has “INPUT”
-- this button serves the purpose of a Source button.
The TV’s clonable features need to be set up. This is a critical step.
If the Master TV display panel’s clonable features like adding channel
icons or channel labels are not done properly, then the cloned TV
TVs will all have problems. Refer to the Owner’s Manual for other TV
features: Video, Audio etc.
LT2002 Clone Programmer
As the cloning procedure is being performed, specific steps need to
be done at the indicated times to achieve the desired result. Be sure
to do each cloning task as indicated. If a procedure or step is left
out or not performed correctly, then the TV
setup will be wrong and cloning may not
work. At each step, pay attention to assure
the TV screen shows the proper message(s)
when cloning. If the message indicated does
not appear, there is a problem with that step
and cloning may not be successful. Cloning is
only possible when the signal source is an
Analog channel, not a digital channel.
Typical Installer Menu
QuickSet II Programmer
LT2002
®
ZENITH ELECTRONICS CORPORATION, LINCOLNSHIRE, ILLINOIS, USA
• heartbeat power on
communications ok
• slow power on
no communications
• green battery ok
• red
battery low
Blink pattern
Color
Reset
Status
Indicator
Connect cable to
TV MPI Jack and
follow on screen
instructions
MPI
ENTER
TV TV
INPUT
INPUT MODE
DVD
MULTI
EXIT
VOL
EZ SOUND INFO SWAP EZ PIC
TIMER
MUTE
CH
SAP
CC RATIO
MENU
VCR
POWER
1 2 3
4 5 6
7 8 9
0 FLASH
BACK
PIP PIP CH - PIP CH + PIP INPUT
PAGE
000 INSTALLER SEQ 000
UPN 000-000-000-000 FPGA E0F1
PTC V1.00.000 CPU V3.06.00
PTC INSTALLER MENU