Wwarning, Cleaning the washer, Regular cleaning – LG WM2487H*MA User Manual

Page 14

Advertising
background image

CLEANING THE WASHER

C A R E A N D C L E A N I N G

w

WARNING:

• Unplug the washer before cleaning to avoid the risk of electric shock. Failure to follow this warning

can cause serious injury, fire, electrical shock, or death.

• Never use harsh chemicals, abrasive cleaners, or solvents to clean the washer.

They will damage the finish.

Cleaning the Dispenser

The dispenser should be cleaned periodically

to remove buildup from detergent and other

laundry products.

Pull out the dispenser drawer until it stops.

Press the button in the center of the drawer

and pull to remove the drawer.

1

Remove the inserts from the drawer, and

clean them with warm water and a soft cloth

or brush to remove any residue or buildup.
Wipe out the inside of the drawer opening

with a damp cloth. Reassemble the drawer

and reinstall in the drawer opening.
NOTE: Do not use anything other than water

to clean the drawer, inserts, and drawer

opening. If any sort of household cleaner

drains into the interior of the washer, run a

RINSE+SPIN cycle before washing clothes.

2

C A R E A N D C L E A N I N G

Cleaning the Exterior

Proper care of your washer can extend its life. The

outside of the machine can be cleaned with warm

water and a mild, nonabrasive household detergent.
Immediately wipe off any spills with a soft, damp cloth.
IMPORTANT: Do not use methylated spirits,

solvents, or similar products.
Never use steel wool or abrasive cleansers; they

can damage the surface.

REGULAR CLEANING

Care and Cleaning of the Interior

Use a towel or soft cloth to wipe around the washer

door opening, door seal, and door glass. These areas

should be kept clean to ensure a watertight seal. Be

sure to wipe under the inside rubber seal to remove

any moisture or soil.
Always remove items from the washer as soon

as the cycle is completed. Leaving damp items in the

washer can cause wrinkling, color transfer, and odor.
Run the TUB CLEAN cycle regularly to remove

detergent buildup and other residue.

Storing the Washer

If the washer will not be used for an extended

period of time and is in an area that could be

exposed to freezing temperatures:

Turn off water supply tap.

Disconnect hoses from water supply and

drain water from hoses.

Plug the power cord into a properly grounded

electrical outlet.

Add 1 gallon of nontoxic recreational vehicle

(RV) antifreeze to the empty wash drum.

Close door.

Select the spin cycle and let washer spin

for 1 minute to drain out all the water.
NOTE: Not all of the RV antifreeze will be

expelled.

Unplug the power cord, dry the drum interior

with a soft cloth, and close the door.

Remove the inserts from the dispenser. Drain

any water in compartments and dry the

compartments.

Store the washer in an upright position.

To remove the antifreeze from the washer

after storage, run washer through a complete

cycle using detergent.

Do not add laundry!

1
2

3

4

5

6

7

8
9

Cleaning the Steam and Water

Circulation Nozzles

Use a cotton swab to remove lime or detergent

buildup from the inside of the steam and water

circulation nozzles.

NEVER use a sharp or

pointed object; you could damage the nozzles.

Removing the Stain in Door Seal

NOTE: Wear rubber gloves and eye protection while

performing the following procedure:

Dilute 3/4 cup (177 ml) liquid chlorine bleach with 1

gallon (3.8 L) of warm/hot water.

Use this solution to wipe down all surfaces of the

gasket to remove the deposits that are causing any

odor. (Be sure to fold back the lip of the gasket to get

under the edge where residue can build up.)

Wipe the gasket with a dry cloth.

Leave the door open to allow the gasket to dry completely.

Do not use undiluted bleach as this will damage the gasket.

Follow the manufacturer’s instructions for proper use of bleach.

If the gasket cannot be cleaned properly, it should be replaced.

Removing Lime Buildup

If you live in an area with hard water, lime scale

can form on internal components of the washer.

Use of a water softener is recommended in areas

with hard water. If a descaler is used, make sure

that it is suitable for use in a washer, and run the

TUB CLEAN cycle before washing clothing.
Lime scale and other spots may be removed

from the stainless steel drum using a stainless

steel cleaner. Do NOT use steel wool or abrasive

cleansers; they can damage the surface.

1

2

3
4





Advertising