Linksys E2000 - Manual (Page 25)

25 Advanced Wireless-N Router
Linksys E2000 Chapter 3: Advanced Configuration
Wireless Security > WEP
Encryption Select a level of WEP encryption, 40/64 bits
(10 hex digits) or 104/128 bits (26 hex digits) . The
default is 40/64 bits (10 hex digits) .
Passphrase Enter a Passphrase to automatically generate
WEP keys . Then click Generate .
Key 1 If you did not enter a Passphrase, enter the WEP
key manually .
RADIUS
This option features WEP used in coordination with a
RADIUS server . (This should only be used when a RADIUS
server is connected to the Router .)
NOTE: If you are using WEP encryption, each
device in your wireless network MUST use the
same WEP encryption method and encryption
key, or else your wireless network will not
function properly .
Wireless Security > RADIUS
RADIUS Server Enter the IP address of the RADIUS server .
RADIUS Port Enter the port number of the RADIUS
server . The default value is 1812 .
Shared Secret Enter the key shared between the Router
and the server .
Encryption Select a level of WEP encryption, 40/64 bits
(10 hex digits) or 104/128 bits (26 hex digits) . The
default is 40/64 bits (10 hex digits) .
Passphrase Enter a Passphrase to automatically generate
WEP keys . Then click Generate .
Key 1 If you did not enter a Passphrase, enter the WEP
key manually .
Click Save Settings to apply your changes, or click Cancel
Changes to clear your changes .
Wireless > Wireless MAC Filter
Wireless access can be filtered (restricted) by specifying the
MAC addresses of the devices in your wireless network .
Wireless > Wireless MAC Filter
Wireless MAC Filter
Enabled/Disabled To filter wireless users by the MAC
addresses of their computers or devices, select Enabled .
Otherwise, keep the default, Disabled .
Access Restriction
Prevent PCs listed below from accessing the wireless
network Select this option to block wireless access by
MAC address . This option is selected by default .
Permit PCs listed below to access the wireless
network Select this to option allow wireless access by
MAC address . This option is disabled by default .