Lance-Larkin BE-112 - Manual (Page 8)

11 12
Carafe or Mug not detected (flashing brew light)
• IRD cannot detect flat black or clear glass mug (change mug color)
• IRD window is dirty (wipe with moist towel and dry)
• Mug not close enough to IRD (move farther into brewer)
• IRD is not set properly, call for technical service.
Water dripping from spray head
• Spray head plugged (replace or clean spray head)
• Normally, some water will drip from the spray head shortly after brewing
• Slight valve leak (debris inside valve, disconnect water and reconnect, run 1-2 full cycles of water in carafe to
dislodge debris and check)
• Valve leak permanent, call for technical service.
Water dripping down walls of carafe area
• Spray head plugged (replace or clean spray head)
• Spray head leak around threads, (remove spray head, clean and re-install for tight fit)
Coffee not staying warm
• Possible carafe vacuum failure (if carafe is warm to touch, replace carafe)
• Preheat carafe before brewing coffee especially if used for half pot. (run brew cycle without filter or coffee)
• Check volume of water by running a full cycle of water without coffee. If carafe overfills call for technical service.
Water leak from back of brewer
• Check quick connect (push connectors together firmly and slightly twist)
• Poly line leak at brewer, call installer to repair.
• Valve connection leak, call for technical service.
trOUBleshOOtinG parts & serviCe
Spare parts are available from Lance Larkin™ (866) 268-5953 or email [email protected].
Contact Lance Larkin™ for all service and warranty issues.
• Spray head
• Brew Basket(s)
• Carafe and lid
• Mounting screws
• Auxiliary water pump and (5) gallon jug.
For installation in areas without water supply.