La Crosse Technology WS-7016U - Manual (Page 2)

5
3. Wait 5-6 minutes, or until the outdoor
temperature is displayed in the OUTDOOR
LCD (Liquid Crystal Display) of the Indoor
Temperature Station.
4. Set the Time (See complete instructions
for details).
5. Mount units.
Note: The Remote Control Sender transmits a
signal every 3 minutes. After the batteries have
been installed, the Indoor Temperature Station
searches for these signals for a duration of 6
minutes. If there is no temperature reading in
the OUTDOOR LCD after 6 minutes, make
sure the units are within range of each other, or
repeat battery installation process.
6
DETAILED SETUP GUIDE
I.
BATTERY INSTALLATION
A. REMOTE CONTROL SENDER
1. Remove the mounting bracket.
The bracket snaps on and off with
minimal effort.
2. Remove battery cover. To do this,
remove the flathead screw located
in the lower-central position of the
unit. The rubber weather-seal
creates a tight seal for the battery
cover, and does not allow the
battery cover to fall away from the
Battery cover
Battery compartment
7
unit. Place the screw partially back
into the hole and angle it slightly,
so the threads grab the battery
cover. With the screw, pull the
battery cover off.
3. Observing the correct polarity,
install 2 AAA batteries. The
batteries will fit tightly—make
sure they do not spring free, or
start-up problems may occur.
4. Check the LCD screen of the
Remote Control Sender to see if
there is a temperature reading. If
there is no reading check the
polarity of the batteries or replace
with new batteries.
5. Observing that the rubber
weather-seal is in place; replace
battery cover, screw, and
mounting bracket.
8
B. INDOOR TEMPERATURE
STATION
Note: After the batteries are installed, DO
NOT press any buttons. This may interfere
with the signals, causing temperatures to
register incorrectly.
1. Remove the battery cover on the
backside. To do this, push up and
pull out.
Battery
Cover