Linksys EtherFast BEFSRU31 - Manual (Page 18)

EtherFast ® Cable/DSL Routers
30
Instant Broadband ™ Series
29
Installing the Windows Millennium Driver
1. With the router connected to your PC’s USB port, start up your PC in
Windows Millennium, and insert your driver disk.
2. Windows will notify you that new hardware has been detected (shown
above). Select “Automatic search for a better drive (Recommended),” and
click the Next button.
3. Windows will display a message saying that it has finished installing the
driver files on your PC. Click the Finish button.
4. Windows will ask you to restart your PC. Click the Yes button.
5. When your PC is finished restarting, click the Start button, and select
Settings, Control Panel, and Network. Make sure that TCP/IP is installed
for your PC as shown on the screen below. If TCP/IP is not installed, please
go to the Installing the TCP/IP Protocol section in the Appendix for
instructions on installation.
Your USB installation is now complete.
Go to the Configuring Your Network with the
Cable/DSL Router section to configure your
network to work with the Router.