Lowrance electronic 5500C - Manual (Page 27)

21
Install the gimbal bracket. Place the bracket so the arms slope toward
the front of your unit.
Once a location is determined, use the bracket as a template and mark
the mounting holes and the hole for the cables. Drill a 1-inch (25.4 mm)
hole in the dash for the power, transducer and antenna cables. Screw
the bracket to the mounting surface.
Front view (left) and side view (right) showing dimensions of the GPS
unit when mounted on gimbal bracket.
To pass all connectors through the 1" hole, first pass the transducer
connector up through the hole from under the dash, followed by the an-
Front
Screw
mounting
hole
Cable hole
Millimeter
[Inch]
244
[9.58]
94
[3.61]
56.9
[2.24]
185
[7.34]
37.1
[1.37]