Lightolier 440 - Manual (Page 2)

XT, XR
XT2/XR2 SERIES 240/340/440
Page 2 of 2 2'x4' LAY-IN RECESSED FLUORESCENT STATIC, FLAT STEEL LENS FRAME (XT)
REGRESSED ALUMINUM LENS FRAME (XR), 2, 3, 4 LAMPS, T8 OR T12
Lightolier a Genlyte Thomas Company www.lightolier.com
Technical Information: (978) 657-7600 • Fax (978) 658-0595
631 Airport Road, Fall River, MA 02720 • (508) 679-8131 • Fax (508) 674-4710
We reserve the right to change details of design, materials and finish.
© 2002 Genlyte Thomas Group LLC (Lightolier Division)
A0902
SECTION 1A/Folio F50-11 REV. B
Job Information Type:
OPTIONS & ACCESSORIES
SPECIAL LENSES: Substitute VB for .125" nominal pattern 12 with 7.8 oz.
average weight per square foot. Substitute VI for .125" nominal pattern 12 with
6.9 oz. average weight per square foot.
ACCESS PLATES: Top wiring access plate is shipped with fixture as standard.
When access plates are required in advance for wiring convenience, specify
separately. Order Catalog Number: ACP CSP.
ELECTRICAL/WIRING OPTIONS: Consult factory.
FUSING:
Internal fast-blow fusing. SUFFIX: GLR.
Internal slow-blow fusing. SUFFIX: GMF.
RADIO INTERFERENCE FILTER 120 or 277 volt, 50 or 60 Hz. One per fixture
is standard. SUFFIX: RF.
SPECIFICATIONS
PERFORMANCE: In an installation of 4 lamp 40 W luminaires in a room cavity
ratio of 1, with reflectance of 80% ceiling, 50% walls, 20% floor, the C.U. shall
not be less than .78. To reduce glare the VCP shall be not less than 42 either
lengthwise or crosswise (at 100 fc level) and the average brightness at 65 shall
not exceed 718 footlamberts. To control veiling reflections, luminaire output in
the 30°-90° zone shall be not less than 66%.
MATERIALS: Chassis parts are die-formed code gauge cold rolled steel.
Housing is embossed for added strength and rigidity with all edges rolled over
for safe handling. Lens frames—(XT) flat full-size steel frame, (XR) regressed
full-size aluminum frame.
FINISH: Chassis exterior—white baked polyester enamel. Cavity—white
baked polyester enamel minimum 86% reflectance. Phosphate undercoating.
LENS: Extruded virgin acrylic 3/16" square based female cones, running 45° to
the panel edge, .095" nominal thickness (similar to pattern 12).
ELECTRICAL: Thermally protected class “P” ballast C.B.M. approved, non PCB.
If K.O. is within 3" of ballast, use wire suitable for at least 90°.
LABELS: I.B.E.W. Listed by Underwriters Laboratories.
PHOTOMETRY
MODEL NO. XT2GVA340120SO
coefficients of utilization — zonal cavity method
RF 20 20 20
RC 80 50 30
RW 70 50 30 50 30 10 50 30 10
1 89 86 83 81 78 76 78 76 74
2 82 76 72 72 68 65 70 67 64
3 76 68 63 65 60 56 63 59 55
4 70 61 55 58 53 49 56 52 48
5 64 55 48 52 47 42 51 46 42
6 59 49 43 47 41 37 46 41 37
7 55 44 38 43 37 33 41 36 32
8 51 40 33 38 33 28 37 32 28
9 47 36 29 34 29 25 34 28 24
10 43 33 26 31 26 22 31 25 22
visual comfort probability
room size ceiling height ceiling height
W L 8.5 10.0 13.0 16.0 8.5 10.0 13.0 16.0
20 20 64 68 75 82 61 65 72 79
20 30 57 61 66 73 54 58 63 69
20 40 54 57 62 66 49 53 58 62
20 60 51 54 57 61 46 49 52 57
30 20 65 69 74 80 63 67 72 78
30 30 58 61 65 70 55 59 62 68
30 40 54 57 60 64 50 53 57 60
30 60 50 53 55 59 46 49 51 55
30 80 49 51 52 55 44 46 48 51
40 20 66 70 75 79 65 69 73 78
40 30 59 63 66 70 57 60 64 68
40 40 55 57 60 63 51 54 57 61
40 60 51 53 55 58 47 49 51 54
40 80 49 51 51 54 44 47 48 51
40 100 49 50 50 52 43 45 45 48
60 30 60 63 66 70 58 62 65 69
60 40 55 58 60 63 53 56 58 61
60 60 51 53 55 58 48 50 51 55
60 80 49 51 51 54 45 47 47 50
60 100 49 50 49 51 44 45 45 48
100 40 58 60 62 65 56 59 61 64
100 60 54 55 56 59 51 53 54 57
100 80 51 52 52 55 48 49 49 52
100 100 50 51 50 52 46 47 46 48
room cavity ratio
luminaries lengthwise luminaries crosswise
ORDERING INFORMATION
Explanation of Catalog Number. Example: XT2GVA340120SOGLR
XT = Recessed
Fluorescent
with Flat Steel
Lens Frame
XR= Recessed
Fluorescent
with Regressed
Aluminum
Lens Frame
G
CEILING TYPE:
G = Grid (lay-in
T-bar)
LAMP QUANTITY:
2, 3 or 4 Lamps
VOLTAGE:
120 or 277 OPTIONS:
Add appropriate
suffix to catalog no,
ie: (GLR)
2
FIXTURE
WIDTH
VA
LENS/SHIELDING
TYPE:
VA = Virgin Acrylic
(standard) see
options and
consult factory
40
LAMP/
FIXTURE LENGTH:
(Nominal 48")
BALLAST TYPE:
LE=Magnetic (T12)
OC=Magnetic (T8)
SS=Electronic (T12)
S3=1-3 Lamp Elect. (T12)
SO=Electronic Elect. (T8)
O3=1-3 Lamp Elect. (T8)
O4=1-4 Lamp Elect. (T8)
DIM=Dimming (T12)
PS=LOL Power Spec T8
Dimming Ballast