Linksys USB100TX - Manual

M a k i n g C o n n e c t i v i t y E a s i e r ™
1. Verify that your PC is powered on and that you are at the Windows
98 desktop.
2. Insert the USB cable’s square B-type plug into the adapter’s B-type
port.
3. Connect your adapter to a hub or switch using a straight-through
network cable. The RJ-45 jacks should fit into the RJ-45 port on
both the adapter and the hub.
• When connecting to a cable or DSL modem, you may have to use
the modem vendor’s Ethernet cable.
4. Insert the other end of the USB cable (the A-type connector) into
your PC’s USB port. The adapter is now connected to your PC.
5. After connecting the EtherFast 10/100 USB Network Adapter, your
computer will automatically detect the presence of the Linksys
USB adapter connected to your computer.
6. When the Add New Hardware Wizard window appears, insert the
EtherFast 10/100 USB Network Adapter Driver Disk into floppy-
drive A and click Next.
7. When the following window appears, select Search for the best
driver for your device (Recommended). Click Next.
8. When the next window appears, select Specify a location and type
a:\Win98 in the drop down box. Click Next.
9. Windows will begin searching your floppy drive for the correct
device drivers. A message will appear that reads Linksys EtherFast
10/100 USB. Click Next.
10. Windows 98 will begin copying a number of files onto your com-
puter.
• If Windows asks you to supply the original Windows 98 CD-ROM,
insert the CD-ROM now and direct Windows to the proper loca-
tion for the disk (e.g. “D:\”). You may also have the Windows 98
setup files already installed in a “CABS” directory (e.g. “c:\win-
dows\options\cabs”). Once this is done, click OK.
• If Windows asks you to supply a driver containing the letters
“usb100”, insert the EtherFast 10/100 USB Network Adapter
Driver Disk into the floppy drive and type a:\win98 in the Copy
Files From box. Click OK.
Continued on back... Continued on back...
This sheet will guide you through the basic steps needed to install this
Linksys product on your computer. If you have any problems during
installation, visit our support page at www.Linksys.com.
Quick Installation
For Windows 98
Model No.: USB100TX
10/100 USB Network Adapter
EtherFast ®