Lucent Technologies Voice Terminal 8434DX - Manual (Page 8)

8
3 To set your selected ringing pattern:
if your 8434DX has a button, press
when you hear the desired ringing pattern;
if your 8434DX has a
button, don’t press
anymore. You will hear the selected ringing
pattern two more times, and then it will be
automatically saved.
•
You hear confirmation tone.
To adjust ringer volume if necessary (speaker is
not active)
1 To raise the volume, press the right half of the
Volume control button labeled ; to lower the
volume, press the left half of the Volume control
button labeled
.
To send all calls (except priority calls) immediately
to coverage
1 While on-hook, press softkey below SAC
(if shown on the display)
or Press
or Dial Send All Calls access code _______.
To cancel Send All Calls
1 While on-hook, press softkey below SAC
(if shown on the display)
or Press
or Dial Send All Calls cancel code _______.
NOTE: To use this feature, your voice terminal must
be set for the Speakerphone (speak and listen)
feature.
To place/answer a call without lifting the handset,
or to use speakerphone with any feature
1 Press .
2 Place or answer call, or access selected feature.
3 Adjust speakerphone volume if necessary:
To raise the volume, press the right half of the Vol-
ume control button labeled
; to lower the vol-
ume, press the left half of the Volume control button
labeled .
SEND ALL CALLS
SPEAKERPHONE
Shift Shift
Ring
Ring
Send Calls
Send Calls
Speaker
8434dx.qref.def3 Page 8 Tuesday, October 21, 1997 1:56 PM