LG LSW200B - Manual (Page 5)

5
EN
G
LI
SH
→ If the screw cannot be assembled in the designated location
inevitably, it can be assembled by rearranging to the closest
location. But, do not change 2 or more locations from the
designated spot.
→ LSW200B/LSW200BG/LSW200BX/LSW200BXG
: Assemble the wall mount screw on 1 left and 1 right location
on the top part and 1 left and 1 right location on the bottom
part.
→ LSW400B/LSW400BG : Assemble the wall mount screw on
2 left and 2 right locations on the top and 1 left and 1 right
location on the bottom part.
→ At this time, use a "+" driver (Manual or motorized) or 8mm
wrench to tighten the screw so that the wall, wall bracket and
screw are completely pressed against one another.
Wall mount screw
LSW400B/LSW400BG Model
<When mounting to wooden studs>
a. Locate and mark the centers of
the wall studs using a stud finder.
b. After aligning the wall bracket on the wall where the center of the wood stud is
marked, mark the location of the screws and then remove the wall bracket.
c. Use a level to make sure your screw marks are level.
d. Use the 4mm drill bit for wood to drill holes with the depth of 76mm or above
where the wall mount screw location is marked on the wall.
e. Clean the drilled hole.
f. Tighten the wall mount screws for the wall bracket on the drilled hole.
→ At this time, tighten the screw so that the wall, wall bracket and the wall mount
screw are pressed against one another. (Drywall can be damaged when tightened
with excessive force, please be careful.)
→ When tightening the screw use the "+" driver (Manual or motorized) or 8mm
wrench.
406mm
drywall
76mm
drywall
wood stud
1. Set the display with the guide spacer assembled on the wall
mount bracket on the wall in arrow direction. At this time, align
the bottom assembly part and lift the set up lightly to align the
top part.
2. When adjusting the location, assemble the provide safety
clip as shown in the picture to prevent the product from
moving. Tighten the safety clip screw completely. If the
safety clip is not tightened as shown in the picture, the
product can fall off.
→ Pull on the bottom of the set to make sure the display is
secure.
→ When installing a display rotated, only rotate the display 90
degrees (portrait mode).
(Only applies for VESA 200X200, 400x400)
→ The clearance from the wall is 14mm for this product. Make
sure to keep a certain level of distance from the wall so
that excessive force is not applied on the cable or accessory.
→ When you push the product with excessive force, the product
can be damaged.
4 How to assemble the wall mount support and display
- Always install the display with 2 or more people.
* Assemble the wall mount
support, product and safety clip.
Safety clip
Safety clip screw