Lincoln Electric CLASSIC 11572 - Manual (Page 8)

A-1 INSTALLATION
CLASSIC® 300D PERKINS
A-1
TEChNICAL SPECIFICATIONS - CLASSIC® 300D PERKINS
Make/Model Description Speed (RPM) Displacement Starting Capacities
System
4 Cylinder 135 cu. in 12VDC battery Fuel: 15 gal.
4 Cycle (2.2 ltrs) (Group 24, 650 57 L.
Perkins Naturally Aspirated High Idle 1800 cold crank amps)
404D-22 Water-Cooled Low Idle 1400 bore x Stroke 2.0 KW Starter Oil: 10.30 Qts.
EPA Diesel Engine Full Load 1725 9.75 L.
Tier 4 interim Cast Iron Cylinder, 3.3” x 3.9”
Compliant Block/Crankcase (84mm x 100mm) Coolant: 9.5 Qts.
32.7HP @1800 RPM 9.0 L.
65 A. Alternator
w/ built in reg.
INPuT - DIESEL ENGINE
RATED OuTPuT @ 104°F(40°C) - WELDER
MODEL hEIGhT WIDTh DEPTh WEIGhT
K1643-7 CSA
w/o Wire Feed Module 1354 lbs.
(Code 11572, 11640) 45.5 in. 24.00 in. 65.0 in. (616 kg)
(1156 mm) (610 mm) (1651 mm
K1643-8 CSA
w/ Wire Feed Module 1389lbs.
(Codes 11573, 11641) (630 kg)
RATED OuTPuT @ 104°F(40°C) - GENERATOR
DESCRIPTION RATED DC OuTPuT * Duty DC CuRRENT RANGE
VOLTS @ RATED AMPS CYCLE Fine Adjustments in each Range
40-350 Amps
220-Max.
300 Amp DC Welder 30V @ 250A 100% 160-240
All Copper Windings 32V @ 300A 60% 120-190
Pure DC Power Generator 99V DC Max. OCV @ 1800RPM 80-130
Min.-90
Auxiliary Power (1)
3,000 Watts Continuous, 60 Hz AC
26 Amps @ 115V
13 Amps @ 230V
PhYSICAL DIMENSIONS (2)
*
Based on a 10 min. period.
(1) Output rating in watts is equivalent to volt-amperes at unity power factor. Output voltage is within ± 10% at all loads up to
rated capacity. When welding, available auxiliary power will be reduced.
(2) Height to top of exhaust elbow.