Linksys PCMPC100 v3 - Manual (Page 9)

EtherFast ® 10/100 PC Cards
If other components are
listed, this is fine. However,
if any components are miss-
ing, you'll need to install
them manually. Refer to
Manually Installing the
Network Components sec-
tion.
If you need to install the
TCP/IP protocol, refer to
your system administrator
or your Windows 95 docu-
mentation. Linksys does
not provide technical sup-
port for the configuration
or troubleshooting of the
TCP/IP protocol.
7. In the Primary Network Logon box, make sure that Client for Microsoft
Networks is selected from the pull down menu. When you reboot, you will
be prompted for a user name and password for Microsoft Networking.
8. To enable File and Printer Sharing, click on the File and Print Sharing but-
ton, then put a check mark next to both boxes in the window. Click the OK
button.
13
Instant EtherFast ® Series
If Windows asks you to supply a file containing the letters “pc100”, type
“a:\” in the box that pops up as shown below. Click the OK button.
During the installation, Windows may ask you for a computer and work-
group name. If so, refer to steps 9 and 10 in this section. Otherwise, con-
tinue with the installation.
Windows will finish copying all of the necessary files to your system.
When asked if you want to restart your computer, click the No button.
Once you are back at the Windows 95 desktop, click on the Start button.
Click on Settings, then Control Panel.
5. Double-click on the Network icon. The Network window will appear. Click
on the Configuration tab.
6. Make sure that the following
network components are
installed:
Client for Microsoft Networks
Linksys EtherFast 10/100 PC
Card (PCMPC100 V3)
TCP/IP
12
N No otte e:: Linksys does
not provide technical
support for TCP/IP
configuration or trou-
bleshooting.
N No otte e:: Linksys does not provide technical sup-
port for TCP/IP configuration or troubleshooting.