LG LSC 26905TT - Manual (Page 8)

8
Water Connection Instruction Guide
Read all directions carefully before you begin. Connecting
the Refrigerator
to a Water Source
Connect to potable water supply only. Warning
• If operating the refrigerator before installing the water connection, turn icemaker
to the OFF position to prevent operation without water.
• All installations must be in accordance with local plumbing code requirements.
• Use copper tubing and check for leaks.
• Install copper tubing only in areas where temperatures will remain above freezing.
• It may take up to 24 hours for your icemaker to begin producing ice.
IMPORTANT
The icemaker water valve contains a flow washer which is used as a water
pressure regulator.
The icemaker needs to be connected to a cold water line with water pressure
30~120psi(lb/inch
2 )
Cold Water Supply
Standard screwdriver
7/16-inch and 1/2-inch open-end wrenches or two adjustable wrenches
1/4-inch nut driver
1/4-inch drill bit
Hand drill or electric drill (properly grounded) Tools Required
• Your refrigerator dealer has a kit available with a 1/4-inch saddle-type shut-off valve,
a union, and copper tubing. Before purchasing, make sure a saddle-type valve
complies with your local plumbing codes. Do not use a piercing-type or 3/16-inch
saddle valve which reduces water flow and clogs more easily.
NOTE
Installation