Lightolier IS:C3MR - Manual (Page 2)

READ AND UNDERSTAND THESE INSTRUCTIONS BEFORE INSTALLING LUMINAIRE
This luminaire is intended for installation in accordance with the National Electrical Code and local regulations.
To assure full compliance with local codes and regulations, check with your local electrical inspector before
installation. To prevent electric shock, turn off electricity at fuse box before proceeding.
Retain these instructions for maintenance reference.
INSTRUCTION SHEET NO.
IS: C3MR
B0206 Page 2 of 2
A COMPANY
631 Airport Road, Fall River, MA 02720
INSTALLATION PROCEDURE FOR CALCULITE
® EVOLUTION TRIMS
8. Install TRIM FACEPLATE by compressing TORSION SPRING
into corresponding detail of TRIM BODY then pushing TRIM
FACEPLATE up flush to ceiling.
Fig’s 4 & 5
TRIM MAINTENANCE
RELAMPING - Make sure that power to luminaire is OFF.
To relamp, simply swing TRIM FACEPLATE down allowing
TORSION SPRING to hold in place. Pull down on LAMP
REMOVAL SPRING. Disconnect LAMP from LAMP
SPRINGS and SOCKET. Install new LAMP following steps
4, 5, and 6 above.
CARE OF ALZAK REFLECTOR- Wipe with a soft, clean,
dry, lint-free cloth, or wipe with a soft clean cloth
dampened in mild detergent solution, then rinse and
dry with a lint-free soft cloth.
Fig. 1
Fig. 2
Securing Clips in
the disengaged
position
Fig. 3
Insert Trim Body
Engage Clip
Trim Body Flush or
slightly recessed
Fig. 4 Fig. 5