Lincoln 1998 Continental - Manual (Page 54)

If you do not successfully program the HomeLink
௡ Universal Transmitter
after repeated attempts, refer to Training a rolling code which follows
or call toll-free customer assistance: 1–800–355–3515.
Note to Canadian residents
During programming, your hand-held transmitter may automatically stop
transmitting after two seconds which may not be long enough to
program the HomeLink
௡ Universal Transmitter.
If you are programming from one of
these hand-held transmitters:
• continue to hold the control on
the HomeLink
௡ Universal
Transmitter
• re-press the hand-held
transmitter every two seconds
You may have to repeat this function
several times while programming.
Operating the HomeLink
ா
Universal Transmitter
Once programmed, the HomeLink
௡
Universal Transmitter can be used in
place of hand-held transmitters. To
operate, simply press the
appropriate channel control on the
transmitter (the red light will
illuminate, indicating the signal is
being transmitted).
Training a rolling code system
Rolling code systems (garage door openers which are “code protected”)
may be determined by the following:
• The hand-held transmitter appears to program the HomeLink௡
Universal Transmitter but does not activate the garage door.
• The garage door opener was manufactured after 1995.
Follow these steps to train a garage door with the rolling code feature:
Controls and features
54