Loewe 52 - Manual (Page 65)

65 -
Troubleshooting
Problem Possible cause Remedy
All menus are displayed in the wrong language. The menu language was set incorrectly. Set the menu language:
Press the INFO button in TV mode (Index).
Mark the first key word and call it with OK.
Then select the language and confirm it with
OK.
In the TV menu, Connections cannot be called
(displayed in grey). A timer recording is in progress. Wait until the timer recording ends or delete
the timer recording (page 55).
The control functions of the Loewe Recorder
and the Timer are not working or are not
working properly a) The Digital Link function is not activated or
not possible in the recorder.
b) EURO-AV cable is not connected.
c) Recorder is not logged in.
a) Activate Digital Link in the recorder (see
operating instructions of the recorder).
b) Connect EURO-AV cable (page 4).
c) Register recorder (page 40).
General problems when connecting external
devices via an AV input.
a) The device is not logged in to the connection
wizard or is connected differently from shown
in the connection diagram.
b) The AV standard is set incorrectly.
c) The signal type is set incorrectly.
a) In the connection wizard (TV menu →
Connections → New devices/modifications)
compare the connection diagram with the
actual installation and connect as shown if
necessary (page 40).
b) Set the correct standard (page 17).
c) Set the correct signal type (page 41).
If AV standard or AV signal is set to "Automatic"
then this can cause errors to be detected with
signals that do not comply with standards.
In this case standard and signal must be set
according to the information in the operating
manual of the external device.
The connection of a decoder does not function
or does not function properly. a) The signal is not decoded because the
correct decoder stations have not been
selected in the connection wizard.
b) In decoder mode the sound is missing
because the wrong decoder sound has been
assigned in the connection wizard.
a) Follow the instructions in the connection
wizard (TV menu → Connections → New
devices/modifications) and select the
appropriate decoder station (page 40).
b) Follow the instructions in the connection
wizard and select the right audio source
(Decoder, TV oder Autom.) (page 40), see
also the decoder manual.