Part 4 install the range, Warning, Anti-tip device installation – LG LDE3017SW User Manual

Page 10: Final installation

Advertising
background image

10

Part 4

INSTALL THE RANGE

Replace the access cover on the back of the range. To
replace the wire cover, insert the two tabs into the
openings located below the opening and tighten the
three screws.

ANTI-TIP DEVICE INSTALLATION

1. Locate the bracket using the template

An Anti-tip bracket is packaged with template. The
instructions include necessary information to
complete the installation.
Read and follow range installation instruction sheet
(template).

2. Level the range

Level the range by adjusting the leveling legs with a
wrench.

Use a level to check your adjustments. Place the level
diagonally on the oven rack, and check each direction
for level.

First check direction

1

.

After check direction

2

.

If the level doesn’t show
level on the rack, adjust the
leveling legs with a wrench.

FINAL INSTALLATION

• Move range close enough to the opening to plug

into the receptacle.

• Slide range into position insuring that the left back

leg slides under the anti-tip bracket. Range should sit
flush against the back wall when properly installed.

• Carefully attempt to tip range forward to insure that

the anti-tip bracket is engaged properly. If properly
installed, the anti-bracket will prevent the range from
being tipped. If the range can be tipped, reinstall the
range until the bracket is properly installed and the
range will not tip forward.

• Turn on electrical power. Check the range for proper

operation as described in owner’s manual.

WARNING

• Any person should not

step or sit on oven door.

You should install the Anti-

Tip Bracket supplied with

the range.

- The range could be tipped and

injury might result from spilled hot

liquid, food, or the range itself.

- If the range is pulled away from

the wall for cleaning, service, or

any other reason, ensure that the

Anti-Tip Device is properly

reengaged when the range is

pushed back against the wall.

Gloves

Safety Glasses

Tape Measure

Pencil

Rear filler & 2 Screws

(LSE Series only)

Gloves

Safety Glasses

Tape Measure

Pencil

Rear filler & 2 Screws

(LSE Series only)

5

6

Advertising
This manual is related to the following products: