Lowrance electronic 500 - Manual (Page 42)

36
waypoint: 1. Press and release ENT . 2. The C REATE W AYPOINT
menu ap-
pears, with the Q
UICK
S
AVE
method selected. To place a waypoint at your
current cursor position, press ENT . The waypoint icon appears on the
map, and a pop-up box tells you the waypoint's name (in this case, "001."
Create a waypoint. The pop-up box with waypoint name is shown at left. At
right, you can see Waypoint 001, with the default waypoint symbol.
This example shows a waypoint set at the cursor location. If the cursor
was not active, the point would be placed at the current position.
Navigate Back to a Waypoint
To navigate to a waypoint that you've created:
1. Press FIND |
↓ to
M
Y
W
AYPOINTS
| ENT|ENT . Press
↑ or ↓ to select from
the list the waypoint you want to navigate to, then press ENT . Use the
navigation arrows on the Map Page or the compass rose on the HSI
Navigation Page to make your way to the selected waypoint.
To cancel navigation, press MENU | MENU |
↓ to
C
ANCEL
N
AVIGATION
| ENT |
←
to Y ES
| ENT . AirMap stops showing navigation information.
Navigate to Cursor Position on Map
The Go To Cursor command navigates to the current cursor position on
the map.
To navigate to a particular location on the map, find location, then se-
lect the location with cursor. Use the Go To Cursor command to lead
you there:
1. Use the cursor (controlled by the arrow keys) with the zoom in and
zoom out keys to maneuver around the map until you find a location
you want to go to.
2. Center the cursor over the location to select it. If you have selected a
location that contains navigation information, the icon you're pointing
at will be highlighted, indicating it's selected. See the example below.
Pop-up box