LG 22LT560C User Manual

Page 7

Advertising
background image

7

ENG

ENGLISH

TABLE OF CONTENTS

TABLE OF CONTENTS

2

IMPORTANT SAFETY INSTRUCTIONS

6

LICENSES

6

OPEN SOURCE SOFTWARE NOTICE

7

TABLE OF CONTENTS

8

INSTALLATION PROCEDURE

8

ASSEMBLING AND PREPARING

8

Unpacking

11

Optional Extras
(For LT560E, LS460E series)

12

Parts and buttons

14

Setting up the TV

14

- Attaching the stand

17

- Mounting on a table

18

- Mounting on a wall

20

- Tidying cables

21

- External Speaker Out

22 REMOTE CONTROL

24 GENERAL TROUBLESHOOTING

24 CAUTION FOR USING EzSIGN 2.0

25 SPECIFICATIONS

27 EXTERNAL CONTROL DEVICE SETUP

27

RS-232C Setup

27

Type of connector;
D-Sub 9-Pin Male

28

RS-232C configurations

29

Communication Parameters

29

Command reference list

30

Transmission / Receiving protocol

FCC NOTICE
This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This equipment generates, uses and can
radiate radio frequency energy and, if not installed and used in accordance with the instructions, may
cause harmful interference to radio communications. However, there is no guarantee that interference
will not occur in a particular installation. If this equipment does cause harmful interference to radio
or television reception, which can be determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and the receiver.
- Connect the equipment to an outlet on a circuit different from that to which the receiver is

connected.

- Consult the dealer or an experienced radio/TV technician for help.
This device complies with part 15 of the FCC Rules. Operation is subject to the following two
conditions: (1) this device may not cause harmful interference and (2) this device must accept any
interference received, including interference that may cause undesired operation of the device.
Any changes or modifications in construction of this device which are not expressly approved by the
party responsible for compliance could void the user’s authority to operate the equipment.

NOTE

y

y

Image shown may differ from your TV.

y

y

Your TV’s OSD (On Screen Display) may
differ slightly from that shown in this manual.

y

y

The available menus and options may differ
from the input source or product model that
you are using.

y

y

New features may be added to this TV in the
future.

Advertising