Connecting the switch, Overview, Before you install the switch – Linksys SGE2000 User Manual
Page 12: Chapter
Chapter
3
8
Chapter 3: Connecting the Switch
Overview
Linksys One Ready Communications Solution
Connecting the Switch
Overview
This chapter will explain how to connect network devices to the Ethernet switch. For an
example of a possible network configuration, see the application diagrams shown below.
Before You Install the Switch...
When you choose a location for the Ethernet switch, observe the following guidelines:
• Make sure that the Ethernet switch will be accessible and that the cables can be easily
connected.
• Keep cabling away from sources of electrical noise, power lines, and fluorescent lighting
fixtures.
• Position the Ethernet switch away from water and moisture sources.
• To ensure adequate air flow, be sure to provide a minimum clearance of two inches
(50 mm) around the air intake and exhaust ports on the sides of the Ethernet switch.
• Do not stack free-standing Ethernet switches more than four units high. The stacking
configuration, described in