LG HCS6300 - Manual (Page 44)

44 206-4122
Satellite Receiver Menu Commands
The following subsections describe how to access and use the Satellite Receiver Menu
commands.
Access the Satellite Receiver Menu
1. Access the card menu for the selected transcoder (see “Access the Transcoder Menu” on
page 40).
2. At the [Card (#)] Command > prompt, type stb and press Enter.
3. At the [Satellite (#)] Command > prompt, either:
• Press Enter to display the Satellite Receiver Menu (see example below).
• Type the desired command and press Enter.
Note: You can always press Enter at the Command > prompt to display the Satellite
Receiver Menu.
Example: Satellite Receiver Menu
-----------------------
Satellite Receiver Menu
-----------------------
getch Read Current STB Channel
setch Set STB Channel
lksts Read Satellite Lock Status
sglvl Read Satellite Signal Strength
actsts Read STB Activation Status
cnum Read Access Card Number
bnum Read STB Serial Number
osdon Set Satellite OSD On
osdoff Set Satellite OSD Off
on Turn STB On
off Turn STB Off (Standby)
stbrst Reset Satellite STB
atune Read Auto Tune Parameters
atset Set Auto Tune Parameters
ret Return to Card Menu
[Satellite (#)] Command >
Configuration Options via Command Line (Cont.)
where:
# is the chassis card/slot
number you selected for
configuration purposes.