Linksys WUSB600N (EU) - Manual (Page 21)

Chapter 3
Advanced Configuration
18 Dual-Band Wireless-N USB Network Adapter
WEP (Wired Equivalent Privacy)
If the network uses WEP encryption, then the WEP Key
or Passphrase Needed for Connection
screen appears.
WEP Security
Passphrase Enter the Passphrase or WEP key.
The passphrase is case-sensitive and must be 16 or
fewer alphanumeric characters. It must match the
passphrase of your other wireless network devices
and is compatible with Linksys wireless products only.
(For non-Linksys wireless products, enter the WEP key
manually.)
If you enter the network’s WEP key, enter the
appropriate number of hexadecimal characters (“0” to
“9” and “A” to “F”). For 64-bit encryption, enter exactly
10 hexadecimal characters. For 128 -bit encryption,
enter exactly 26 hexadecimal characters.
To connect to the network, click Connect. To cancel
the connection, click Cancel.
Click 2. Finish.
Congratulations
Congratulations! The profile is
successfully configured.
Advanced Setup
If your network is not listed with the available networks,
use Advanced Setup.
Available Wireless Networks
Click 1. Advanced Setup on the Available Wireless
Networks screen to set up the Adapter manually.
The 2. Network Settings screen appears.
Wireless Network
If your network has a router or other DHCP server, select
Obtain network settings automatically (DHCP).
If your network does not have a DHCP server or router,
select
Specify network settings. Enter an IP Address,
Subnet Mask, Default Gateway, and DNS addresses
appropriate for your network. You must specify the
IP Address and Subnet Mask on this screen. If you are
unsure about the Default Gateway and DNS addresses,
leave these fields blank.
IP Address – This IP Address must be unique to
your network.
Subnet Mask – The Adapter’s Subnet Mask must be
the same as your wired network’s Subnet Mask.