Little Wonder Line Trimmer - Manual (Page 9)

8
Maintenance
Area Maintenance procedure Frequency
Spline male/female connection of the
inner drive shaft
Inspect/Lubricate
1. Remove center screw, and loosen up
other two as shown on the diagram
(left).
2. Pull the shaft from the gear housing.
3. Pull and clean internal shaft.
4. Lubricate.
5. Re-install the drive shaft.
20-25 Hrs
Gear case
Inspect/Clean debris
Remove plug and check level of grease.
Add grease. Do not overfill!
Use EP2 lithium grease 45-50 Hrs
Screws/Nuts/Bolts Inspect/Tighten/Replace Before each use
Remove
Loosen
Pull
Lubricate
Gear Case Plug
Area Maintenance Before Every 25 Every 50 Every 100 Note
Use Hours Hours Hours
Cutting Parts Replace if
✔
something is wrong
Screws, nuts Tighten, replace
✔ ✔
Not adjusting
bolts screws
IMPORTANT: Time intervals shown are maximum. Actual use and your experience will determine the frequency of
required maintenance.