LOREX Technology LW2301 - Manual (Page 16)

Remote Control
12
Remote Control
ATTENTION: Before using the remote
control, remove the protective clear
plastic tab from the battery cover.
1. 1/
f
: Move menu cursor UP;
play/pause playback; jump to
camera 1 while in Quad Mode.
2. Enter: Confirm menu selections
(same as OK on the wireless
receiver).
3. 4/ : Move menu cursor LEFT;
decrease values in certain menu
options; rewind playback; jump to
camera 4 while in Quad Mode.
4. MENU / Back: Press to open the
Main Menu; go back/close menu
windows.
5. Record: Press Motion to enable
motion recording – system will
ONLY record when motion is
detected; press
to start/stop
manual recording.
6. Volume: Press to
increase/decrease volume during
playback. Use the receiver to
change volume of buzzer and
motion alarm.
7. Quad: Press to change the display
view to quad (4-way) split-screen.
8. 2/ : Move menu cursor RIGHT;
increase values in certain menu
options; increase playback speed;
jump to camera 2 while in Quad
Mode.
9. 3/ : Move menu cursor DOWN;
decrease values in certain menu
options; stop playback; jump to
camera 3 while in Quad Mode.
10. Scan/Del: Press to delete
recorded video files.
11. Channel: Press “A” to enable/disable Auto Sequence Viewing Mode; press M to manually change
the channels (1~4).
12. AV: Not used.
NOTE: Unless otherwise noted, button names mentioned in steps in this manual will refer to
buttons on the remote control.
1
2
3
4
5
6
8
9
10
11
12
7
Figure 1.0 Remote Control