LG LRSC 26944SW EN - Manual (Page 10)

10
Operation Instruction Guide
Before making the connection to the refrigerator, be sure the refrigerator
power cord is not plugged into the
wall outlet.
•
If your refrigerator does not have a
water filter, we recommend
installing one. If your water supply
has sand or particles that could clog
the screen of the refrigerator’s
water valve. Install the filter in the
water line near the refrigerator.
Remove the plastic flexible cap
from the refrigerator connection.
1. Remove the plastic flexible cap
from the water valve.
2. Place the compression nut and
ferrule (sleeve) onto the end of the tubing as shown.
3. Insert the end of the copper tubing into the connection as far as possible. While
holding the tubing, tighten the fitting.
Connect the Tubing
to the Refrigerator
Tighten any connections that leak.
Plug In the Refrigerator
Arrange the coil of copper tubing behind the refrigerator so it does not vibrate
against the back of the refrigerator or against the wall. Push the refrigerator
back to the wall.
Start the lcemaker
Set the icemaking stop switch to the ON position The icemaker will not begin
to operate until it reaches its operating temperature of 15 °F (-9 °C). It will then
begin operation automatically if the icemaking stop switch is in the ON
position.
Turn the Water On at
the Shutoff Valve
The automatic icemaker makes 8 cubes at a time, 120/150 pieces per day.
But these quantities may vary according to circumstance, including ambient
temperature, door openings, freezer load.etc.
The Icemaker stops when the bin is full.
Automatic Ice maker
Refrigerator
Connection
Ferrule
(sleeve)
1/4"
Compression
Nut
Tubing
Clamp
1/4"
Tubing
• It is normal to hear a noise when ice drips into the bin.
NOTE
Installation