Lucent Technologies LambdaUnite Multiservice Switch - Manual (Page 2)

To Learn more about our comprehensive portfolio, please
contact your Lucent Technologies Sales Representative or
call 1-888-426-2252.
Visit our web site at http://www.lucent.com.
This document is for planning purposes only, and is not intended
to create, modify or supplement any Lucent Technologies
specifications or warranties relating to these products or services.
Information and/or technical specifications supplied within this
document do not waive (directly or indirectly) any rights or
licenses – including but not limited to patents or other protective
rights – of Lucent Technologies or others.
LambdaUnite and Navis are registered trademarks of
Lucent Technologies Inc.
Telcordia and NEBS are registered trademarks or trademarks of
Telcordia Technologies Inc.
UL is a registered trademark of Underwriter’s Laboratories Inc.
Copyright © 2005
Lucent Technologies Inc.
All rights reserved
ONG v7.0305
Technical Specifications (continued)
4.Switch Architecture and Connectivity
Redundant switch fabric (including 160G, 320G and 640G
capacities) and timing unit provides non-blocking connectivity
at AU-4/HO VC-3 and STS-1 level. Concatenation up to
AU-4/4c/16c/64c, STS-1/3c/12c/48c/192c including pipe mode.
15G VC-12/VC-3/VT-1.5 LO-XC adjunct switch fabric
Dual System Controllers (1 + 1) – optional
5.Timing & Synchronization
a. Timing inputs/outputs: DS-1 Telcordia ® ,
ITU-T 2Mhz, 2Mbps
b. Timing Quality: Stratum 3
c. System timing references: Reference selection acc. to
ETSI 300417.1.1/ITU-T G.781 and Telcordia ® GR253
6.Fault & Performance Monitoring
a. Performance Monitoring:
Telcordia ® GR-253-CORE, ITU-T G.784, G.826
b. Local NE alarm indication:
Critical, Major and Minor alarm LED
c. Autonomous alarm forwarding
d. Test access
7.Network Management
a. Transport protocols: OSI, TCP/IP, DCCm and DCCr,
Ethernet communication ports
b. Management Interface: TL-1
c. Management Systems:
Lucent Technologies Optical Craft Interface (OCI),
Navis
® Optical Management System
Telcordia ® compliant OS
8.Physical Design
a. Sub-rack design: ETSI & GR78 compliant
b. Width: 500mm / 19.7inch
Height: 950mm / 37.4inch
Depth: 545mm / 21.5inch
c. Two systems per ETSI 2.2m and 2.6m rack or GR-63
(NEBS™ 2000) 83.7inch rack
9.Connectors
LC connectors. Conversion solutions to other common
connector types available
10.LambdaUnite ® MSS Rack Design
a. LambdaUnite ® MSS ETSI-2 rack
600 x 2200 x 600 mm (w x h x d)
23.6 x 86.6 x 23.6 in (w x h x d)
b. LambdaUnite ® MSS GR-63:
23.6 x 83.7 x 23.6 in (w x h x d)
(NEBS™ 2000) rack:
600 x 2125 x 600 mm (w x h x d)
c. Earthquake safety standards
Both subrack-rack combinations are certified as defined
for geographic areas labeled as risk zone 4 (GR-63)
11.Power Supply
a. Redundant primary power supply voltage:
–60 / –48V nominal
b. Operation range: –40V to –72V
c. Power consumption: Typical 2500W per NE
12.Environmental Conditions
a. EMC:
EN300 386-2, IEC 61000-4-x series (immunity)
Telcordia
® GR-1089-core (emission and immunity)
b. Climate:
System meets ETSI 300 019 requirements on
environmental conditions:
ETSI Class 3.1 on Operation (5°C to 40°C;
short term –5°C to 50°C)
ETSI Class 1.2 on Storage
ETSI Class 2.3 on Transportation
Telcordia
® GR-63
(Operating Temp.: 41°F to 104°F;
short term: 23°F to 122°F)
c. Humidity: Operating 5% to 85%; short term 5% to 90%
d. Noise: System complies with ETSI 300 653 and NEBS™ 4.6
e. Laser Safety:
Hazard level 1 or 3A for all circuit packs acc. IEC 60825
13.Product Certifications
CE marking; NEBS™ Level 3 compliant; FDA approval;
UL
® listed