Lenoxx Electronics PH-301 - Manual (Page 5)

TELEPHONE OPERATION
Setting the Pulse/Tone Switch
Set the switch at TONE position for tone type, or set the switch at
PULSE position for pulse (rotary) type (clicking sounds).
If you are not sure which setting you need, try dialing a call with the
switch set to TONE. If the call cannot connect, switch to PULSE.
Ringer HI/LOW/OFF Switch
OFF - The ringer does not sound, for undisturbed privacy.
LOW - Lower rings on incoming calls.
HI - Loud rings on incoming calls.
NOTE: If the RINGER switch is in the OFF position, only THIS
phone will not ring, the other phones in your home will
continue to ring.
Receiving Calls
1. Pick up the handset when the phone rings.
2. Hang up the handset to release the telephone line when
conversation is completed.
Making Calls
1. Select the desired dialing mode with the PULSE/TONE switch.
2. Pick up the handset and listen for a dial tone.
3. Dial your call.
Last Number Redial
1. To redial last number, just press RESET to get a new dial tone
then press the REDIAL/PAUSE button.
2. This phone will keep the last number dialed in memory even
overnight.
Mute Button
Allows you to hear the other party without them hearing you. To use
the mute function, press and hold down the MUTE button.
Release the button to return to normal.
WALL MOUNTING WITHOUT A WALL PLATE
FOLLOW THESE INSTRUCTIONS TO
MOUNT THE PHONE ON THE WALL
WITHOUT A STANDARD WALL
PLATE.
1. Drill 2 holes 3 15 /
16
" (100mm)
apart.
2. Put a screw into each hole and
leave 3 /
16
" (5mm) of the head
exposed.
3. Connect the straight cord to the
phone and wall jack.
4. Put the key hole slots over the
screws and slide down to secure
phone.
4
Handset Volume Control
You can adjust the sound level of the handset receiver by adjusting
the VOLUME control setting.
Make sure space
between holes is
Drill one hole
Drill one hole
NOTE: Even when your phone is set to pulse service, this phone
can be switched to temporary tone dialing for access to
services that require tone signaling like computer systems.
Just press the button after dialing in pulse and your
buttons can now be used for tone signaling for this call only.
Pause Function
If you make a dial with a pause in the number, simply press the
REDIAL/PAUSE button for the pause.
100 mm
IB-PH301(MS)-WM-E-113003
IB-PH301(MS)-E-113003.p65 11/27/02, 2:11 PM 5