Linksys WPS54GU2 User Manual
Page 40
33
Wireless-G PrintServer for USB 2.0
Chapter 8: Bi-Admin Management
The Bi-Admin Management Utility
•
Configure. You may configure the PrintServer with this option. If you click this option, a Verify Password
screen will appear. Make sure that you enter the password in the field before you click OK, or else an
Incorrect Password message will appear. If the message appears, click OK. Enter the correct password in the
field provided, and click OK again.
After the password has been successfully entered, the Configuration screen will appear, as shown in Figure
8-12. It displays eight tabs: System, TCP/IP, AppleTalk, NetBEUI, Internet Printing, Port, Wireless, and SNMP.
The tabs will be described below.
System
•
Device Name. Enter the Device Name in the field provided.
•
Comment. Enter any comments in the Comment field.
•
Device Password. To change the password, select Change Device Password, enter the new password
in the Password field, and then re-enter the password in the Confirm Password field.
•
Protocol. Select the protocol you want to use for your network: TCP/IP, AppleTalk, NetBEUI, IPX/SPX.
Click the Get Defaults button if you want to cancel your changes and use the default settings.
When finished making your changes on this tab, click the OK button to save these changes, or click the
Cancel button to undo your changes. For more information, click the Help button.
Figure 7-11: Verify Password
Figure 7-12: Configuration - System