Lenoxx Electronics PH5435 - Manual (Page 10)

IB-PH5435-WC-E-032805
NOTE:
1. You do not have to set up the Time and Date manually because
the telephone company will automatically update this with the
Caller’s ID information when your phone rings (twice or more).
To get back to the standby mode (for dialing), press the
DELETE button repeatedly until the normal display shows.
2. The factory’s default setting of the dialing mode is TONE, so
you don’t need to set it again if you want to use TONE dialing
mode.
3. When your phone is set to pulse service, this phone can be
switched to temporary tone for access to services that require
tone signaling including Telephone Banking. Just press the
TONE button after dialing in pulse and your buttons can
now be used for tone signaling for this call only.
8
If you have subscribed to the Caller ID service, the caller’s number
and/or name will appear in the display when you receive a call.
BASICS
Making and Receiving Calls
MAKING A CALL
1. Pick up the handset.
2. Dial the phone number. The dialed number appears in the
display.
3. When you finish talking, replace the handset into the base.
RECEIVING A CALL
1. Pick up the handset when the phone rings.
2. When you finish talking, replace the handset into the base.
Volume Control and Ringer Setting
Flash Function
Useful for call waiting or getting a new dial tone.
If you need a pause in a number, simply press the REDIAL/PAUSE
button on your phone. (Example: In an office where you need to dial
a 9 first to get an outside line), dial the number 9 and press the
REDIAL/PAUSE button, and then dial the phone number. You will
see a “ ” displayed for PAUSE. You may also store this into memory..
Adjust the handset volume
Slide the VOLU ME control to
NORMAL or LOUD position.
Adjust the ringer level
Set the RINGER switch.
HI - loud rings on incoming calls.
LOW - lower rings on incoming calls.
OFF - no ringing on incoming calls.
Last Number Redialing / Pause Function
1. Pick up the handset.
2. Press the REDIAL/PAUSE button. The last dialed number
appears in the display and is automatically dialed.
IB-PH5435-WC-E-032805.pmd 4/1/2005, 12:28 PM 10