About the shelves and bins – LG 22 User Manual

Page 8

Advertising
background image

Consumer Support

Troubleshooting T

ips

Operating Instructions

Safety Instructions

Installation Instructions

Troubleshooting T

ips

Installation Instructions

Safety Instructions

Operating Instructions

Troubleshooting T

ips

Installation Instructions

Safety Instructions

Operating Instructions

8

About the shelves and bins.

Non-Adjustable Shelves on the Door

To remove: Lift the shelf straight up, then
pull out.

To replace: Engage the shelf in the molded
supports on the door and push down.
It will lock in place.

Adjustable Bins on the Door

Adjustable bins can easily be carried from
refrigerator to work area.

To remove: Lift the bin straight up, then
pull out.

To replace or relocate: Engage the bin in the
molded supports of the door, and push in.
Bin will lock in place.

The snugger helps prevent tipping, spilling
or sliding of small items stored on the door
shelf. Grip the finger hold near the rear of
the snugger and move it to fit your needs.

Snugger

Freezer Tilt Out Bin

(on some models)

Push the button as you tilt out the bin.

To remove: Hold the sides of the bin and
lift it straight up, then pull out.

To replace: Engage the ends of the bin
in the molded supports on the door and
push down. It will lock in place.

NOTE: Do not overload the bin.

Slide-Out Spillproof Shelf

(on some models)

The slide-out spillproof shelf allows you
to reach items stored behind others. The
special edges are designed to help prevent
spills from dripping to lower shelves.

To remove:

Remove all items from shelf.

Slide the shelf out until it stops.

Lift the front edge of the shelf until the

central tabs are above the front bar.

Continue pulling the shelf forward

until it can be removed.

To replace:

Place the rear shelf tabs just in front of

the central notches on the shelf frame.

Slide the shelf in until the central tabs

are slightly behind the front bar.

Lower the shelf into place until it is

horizontal and slide the shelf in.

Make sure that the shelf sits flat after reinstallation
and doesn’t move freely from side to side.

Make sure you push the shelves all the way in
before you close the door.

Finger hold

Advertising
This manual is related to the following products:

25