Linksys WVC11B - Manual (Page 15)

8 Chapter 4: Connecting the Wireless-B Internet Video Camera for Setup
Overview
Wireless-B Internet Video Camera
Chapter 4: Connecting the Wireless-B Internet Video Camera
for Setup
Overview
Before you set up the Camera, connect it to a wired or wireless network. Proceed to the appropriate section for
your setup.
If you need to move the Camera from a wired network to a wireless network, or vice versa, go to this section,
“Moving the Camera to a Different Network.”
Connection to a Wired Network for Setup
1. Connect the Ethernet network cable to your router or switch. If you want to connect the Camera directly to
your PC, use a crossover Ethernet network cable (not included).
2. Connect the other end of the cable to the LAN port on the Camera. See Figure 4-1.
3. Connect the power adapter to the Power port on the Camera.
4. Plug the power adapter into an electrical outlet.
The Camera’s Ready LED flashes while the Camera is initializing. The Camera is ready for use when the Ready
and LAN LEDs are solidly lit.
Proceed to “Chapter 5: Setting up and Mounting the Wireless-B Internet Video Camera.”
Connection to a Wireless Ad-Hoc Network for Setup
1. Make sure your computer has the following wireless settings:
• SSID - linksys
• Network Mode - Ad-Hoc
• Channel - 6
• WEP - Disabled
2. Connect the power adapter to the Power port on the Camera.
NOTE: You MUST connect the Camera to a PC,
router, or switch using the Ethernet network
cable BEFORE powering on the Camera.
Otherwise, the Camera will not function.
Figure 4-2: Connect the Power Adapter
Figure 4-1: Connect the Ethernet Network Cable