LG 29FS2AMB/ANX - Manual (Page 13)

11. Deflection setting initial data
* Check adjustment condition at 1080i/50Hz, NTSC60Hz after
finishing adjustment in PAL100Hz, adjust defection
adjustment at each Mode again.
* Sequence
:PAL 100Hz(RF) -> NTSC 60Hz(RF) ->
1080i/50Hz(COMPONENT)
12. How to inspect condition of a
transmission and reception in
wireless sound model(option)
- Wireless sound model’s efficiency inspections is executed to a
finished in a final inspection phase.
- Wireless sound is a function which receives voice-signal by an
exclusive remote control and Earphone, transmits a FM
through transmitter of inner part in MICOM BOARD to TV
sound(MONITOR OUTPUT)
1) Execute in channel generating voice-signal
2) Select a transmitted frequency in MENU OSD.
3) A received frequency in an exclusive remote control or
received FM Radio is tuned by 87.7MHz which is same as
frequency in OSD.
4) Check out whether a signal generating to MAIN SPEAKER
generates in earphone or receiver or not.
5) There is no alternation and setting of adjusted DATA in the
process of inspecting FM TX.
13. OPTION setting
13-2. Preliminary steps
1) This option adjustment decides function in accordance with
model. Press the SVC TX adjustment button(CH up/down
button) at SVC mode, then adjust the option at OPTION1, 2,
3, 4, 5 mode.
2) Mark the option adjustment data like [111,111,111,111,111]
in BOM.
13-2. Adjustment Method
1) Input OPTION value with number button on remote control at
each OPTION adjustment mode.
2) At each OPTION Mode, Select adjustment item by the CH D ,
E button and then set up each OPTION by the F , G button.
ITEM
VL
VA
SC
VS
HS
EW
ET
EP
CRNU
CRNL
BOW
ANGLE
CRNU6
CRNL6
0 ~ FFFF
0 ~ FFFF
0 ~ FFFF
0 ~ FFFF
0 ~ FFFF
0 ~ FFFF
0 ~ FFFF
0 ~ FFFF
0 ~ FFFF
0 ~ FFFF
0 ~ FFFF
0 ~ FFFF
0 ~ FFFF
0 ~ FFFF
FFFC
004E
009E
FFF8
005D
0044
FFFB
FFD0
0004
000B
000B
000A
0056
003F
FFF3
0014
009E
FF10
005E
0041
FFDE
FEE2
0004
0025
0007
0009
003A
0030
FFDD
002A
007C
0003
005C
006C
FFC0
FE94
FFF6
002A
0007
0009
0056
0042
Range
RF PAL
100Hz 1080i/50
RF NTSC
1080i/50
OP [113,63,112,201,248]
OPTION 1
OPTION 2
OPTION 3
OPTION 4
OPTION 5
* Mark of BOM
LEVEL PART NO. SPECIFICATION DESCRIPTION
1. 3141VMNxxxA MAIN CHASSIS ASSY OPT[091,016,143,100,000]
In this model, the OPTION1 data is 091, OPTION2 data is 016, the OPTION3
data is 143,the OPTION 4 data is 100, OPTION 5 data is 000.