LG LH-E9674 - Manual (Page 12)

12
Setting up the unit
The picture and sound of a nearby TV, VCR, or radio
may be distorted during playback. If this occurs,
position the unit away from the TV, VCR, or radio, or
turn off the unit after removing the disc.
The unit Connections
Depending on your TV and other equipment there are
various ways you can connect the unit. Please refer to
the manuals of your TV, stereo system or other
devices as necessary for additional connection
information.
Video Connections to Your TV
Make sure the unit is connected directly to the TV and
not to a VCR, otherwise the DVD image could be
distorted by the copy protection system.
Video: Connect the MONITOR OUT jack on the
unit to the video in jack on the TV using the video
cable (V).
S-Video: Connect the S-VIDEO OUT jack on the
unit to the S-Video in jack on the TV using the S-
Video cable (S).
Notes:
• For MONITOR OUT and S-VIDEO OUT jack
connection, resolution must be set to 480i or 480p
by pressing RESOLUTION on the Remote Control,
however MONITOR OUT and S-VIDEO OUT is
always at 480i standard resolution.
• HDMI mode must be set to OFF for VIDEO OUT
and S-VIDEO OUT jack connection.
Component Video (ColorStream ® ): Connect the
COMPONENT VIDEO OUT jacks on the unit to
the corresponding in jacks on the TV using an Y
Pb Pr cable (C).
Progressive Scan (ColorStream Pro ® ):
• If your television is a high-definition or
“digital ready” television, you may take
advantage of the unit’s progressive scan output
for the highest video resolution possible.
• If your TV does not accept the Progressive
Scan format, the picture will appear scrambled if
you try Progressive Scan on the unit.
Notes:
• You can change the resolution (480i, 480p, 720p,
1080i) for the COMPONENT VIDEO OUT by
pressing RESOLUTION on the Remote Control.
• For 720p and 1080i resolution, only non-copy
protected discs can be played back. If the disc is
copy protected, it will be displayed at the 480p
resolution.
The resolution (720p, 1080i) is for the component
and HDMI outputs only.
• HDMI mode must be set to OFF for Component
video connections.
• The resolution (720p, 1080i) does not work with the
analog video connections (VIDEO OUT & S-VIDEO).
MONITOR
OUT
COMPONENT VIDEO OUT
FM
COAXAL IN
Installation and Setup