Linksys EFG80 - Manual (Page 7)

Etherfast Network Attached Storage
Chapter 4: Using the Instant
GigaDrive’s Setup Wizard
Now that everything is connected and powered on, you are ready to configure
your Instant GigaDrive so that it is accessible to the users on your network. You
will have to runl the Instant GigaDrive’s Setup Wizrd on your PC to access the
GigaDrive’s Quick Setup feature. To run the Setup Wizard on your Windows
98, Me, NT 4.0, 2000, or XP PC, follow the instructions below.
1. Insert the Setup Wizard CD-ROM into your PC’s CD-ROM drive.
2. An autorun menu should appear a few seconds after you insert the CD into
your CD-ROM drive. If the autorun menu does not appear after a minute,
click the Start button, select Run, type D:\SetupWizard.exe (where D is
the letter of your CD-ROM drive) into the Open window and press Enter.
The autorun menu appears as shown in Figure 4-1.
9
Instant GigaDrive TM Series
5. Power on. Locate the Instant GigaDrive’s power switch on the rear panel.
Press it once to power on the Instant GigaDrive™. Then, power on the net-
work printer, if you attached one to the Instant Gigadrive™.
6. Now that its power is on, the Instant GigaDrive’s boot process will begin.
The Instant GigaDrive™ will run a brief self-test (two or three seconds)
prior to actually booting up. During the Self-Check, most of the
GigaDrive’s LEDs will be lit up or flashing. This should take a few min-
utes. The initial bootup, will take a bit longer, as well as any bootup fol-
lowing an improper shutdown.
7. When most of the LEDs turn off, leaving only the Ready LED lit up (and
not blinking), the GigaDrive’s boot up is complete. If the Error LED is
flashing, or if the GigaDrive repeatedly beeps, there is a hardware problem.
Review the Beeper Codes section in Chapter Two for possible solutions.
8
Figure 4-1