Lanier AP3200 - Manual (Page 129)

Moving and Transporting the Printer
115
7
❖ ❖ ❖ ❖ Mailbox (CS370)
After removing the four mailbox
trays, follow these steps.
A If the duplex unit is installed,
open the duplex unit by lifting
the catch.
B Open the right cover of the
printer by lifting the catch, and
open the upper cover of the in-
terchange unit by pulling the
handle.
C Use a coin to remove the two
screws securing the mailbox to
the printer.
D Pushing the lever inside the up-
per cover (A), lift the mailbox
and remove it from the printer.
❖ ❖ ❖ ❖ 500–sheet finisher (SR510)
After removing the finisher tray,
pull the lock under the finisher (A),
lift the finisher and remove it from
the printer.
❖ ❖ ❖ ❖ 1000–sheet finisher (SR720)
If you want to remove the 1000–
sheet finisher, contact your sales or
service representative.
Important
❒ Be sure to disconnect all cables
from the printer before transport-
ing it.
❒ The printer is a precision piece of
machinery. Take care to avoid
damage during shipment.
A
Slide out the four handles on both
sides of the printer.
B
By holding the handles, lift the
printer. The printer should be
held by at least two people.
Moving the Printer Close by
A
Turn off the printer, and remove
all cables and cords from the
printer.
B
Keeping the printer level, lift and
move it.
ZAEP730E
A
A
ZDEP350E
ZAEP040E
ZAEP600E