LaCie 319 - Manual (Page 21)

Possible Solutions
• The signal cable should be completely connected to the display card/computer.
• The display card should be completely seated in its slot.
• Check the Vacation Switch should be in the ON position.
• Front Power Switch and computer power switch should be in the ON position.
• Check to make sure that a supported mode has been selected on the display card or system
being used.
(Please consult display card or system manual to change graphics mode.)
• Check the monitor and your display card with respect to compatibility and recommended set-
tings.
• Check the signal cable connector for bent or pushed-in pins.
• Check the signal input, “INPUT 1” or “INPUT 2”.
• Ensure the DVI input mode is set to DIGITAL when the MAC digital output is connected to the
DVI-I (Input1) connector.
• Unplug the power cord of the monitor from the AC outlet to turn off and reset the monitor.
• Check the Vacation Switch on the left side of the monitor.
• Please be aware that LCD Technology may experience a phenomenon known as Image
Persistence. Image persistence occurs when a residual or “ghost” image of a previous image
remains visible on the screen. Unlike CRT monitors, LCD monitors’ image persistence is not perma-
nent, but constant images being displayed for a long period of time should be avoided. To alleviate
image persistence, turn off the monitor for as long as the previous image was displayed. For
example, if an image was on the monitor for one hour and a residual image remains, the monitor
should be turned off for one hour to erase the image. NOTE: As with all personal display devices,
LaCIe recommends displaying moving imagesand using a moving screen saver at regular intervals
whenever the screen is idle or turning off the monitor when not in use.
• Image is displayed only roughly (pixels are missing) and OSM warning “OUT OF RANGE” is
displayed: Either signal clock or resolution is too high. Choose one of the supported modes.
• OSM warning “OUT OF RANGE” is displayed on a blank screen: Signal frequency is out of
range. Choose one of the supported modes.
4. Troubleshooting
page 21
LaCie 319 LCD Monitor
User’s Manual
The Problem
No picture
Power Button does not
respond
Image persistence
Message “OUT OF
RANGE” is displayed
(screen is either blank or
shows rough images
only)
4. Troubleshooting