Installation, Caution warning – Lincoln Electric IM870-A User Manual

Page 12

Advertising
background image

A-5

INSTALLATION

SAE-400 SEVERE DUTY

A-5

WELDING OUTPUT CABLES

With the engine off, connect the electrode and work
cables to the studs provided. These connections
should be checked periodically and tightened if neces-
sary.

Listed in Table A.1 are copper cable sizes recom-
mended for the rated current and duty cycle. Lengths
stipulated are the distance from the welder to work
and back to the welder again. Cable sizes are
increased for greater lengths primarily for the purpose
of minimizing cable voltage drop.

Table A.1 Combined Length of Electrode and

Work Cables.

MACHINE GROUNDING

Because this portable engine driven welder creates its
own power, it is not necessary to connect its frame to
an earth ground, unless the machine is connected to
premises wiring (home, shop, etc.).

To prevent dangerous electric shock, other equipment
powered by this engine driven welder must:

a) be grounded to the frame of the welder using a

grounded type plug,

or

b) be double insulated.

When this welder is mounted on a truck or trailer, its
frame must be securely connected to the metal frame
of the vehicle. When this engine driven welder is con-
nected to premises wiring such as that in a home or
shop, its frame must be connected to the system earth
ground. See the article on grounding in the latest U.S.
National Electrical Code and the local code.

In general, if the machine is to be grounded, it should
be connected with a #8 or larger copper wire to a solid
earth ground such as a metal water pipe going into
the ground for at least ten feet and having no insulat-
ed joints, or to the metal framework of a building
which has been effectively grounded. The U.S.
National Electrical Code lists a number of alternate
means of grounding electrical equipment. A machine
grounding stud marked with the symbol is provid-
ed on the welding generator frame foot.

Up to 100 FT.

(Up to 30m)

2/0 AWG

100-200 FT.

(30m-61m)

3/0 AWG

200-250 FT.

(61m-76m)

4/0 AWG

AMPS

@60%

Duty Cycle

400

TOTAL COMBINED LENGTH OF ELEC-

TRODE AND WORK CABLES

SPARK ARRESTOR

Some federal, state or local laws may require that
diesel engines be equipped with exhaust spark
arrestors when they are operated in certain locations
where unarrested sparks may present a fire hazard.
The welder was shipped from the factory with a sepa-
rate spark arresting unit. If a spark arrestor is required
secure the spark arrestor to the outlet tube of the muf-
fler using the clamp provided. Any spark arrestor must
be serviced and properly maintained.

An incorrect spark arrester may lead to damage to
the engine or adversely affect performance.
------------------------------------------------------------------------

WARNING

Allow engine to cool before

Do not operate engine while

servicing spark arrestor!

servicing spark arrestor!

Spark Arrestor and Muffler may be hot!

CAUTION

WARNING

Advertising