Door replacement feed water pipe installation, Installation – LG SXS User Manual
Page 7
7
Door replacement
Feed water pipe installation
Pass the refrigerator laterally through the access
door as shown in the right figure.
Automatic ice maker operation needs water pressure of 147~834 kPa (1.5~8.5
kgf/cm
2
) (That is, an instant paper cup (180 cc) will be fully filled within 3 sec.).
If water pressure does not reach the rating 147 kPa (1.5 kgf/cm
2
) or below, it is
necessary to purchase a separate pressure pump for normal automatic icing and
cool water feed.
Keep the total length of the feed water pipe tube within 8 m and be careful for the
tube not be bent. If the tube is 8 m or longer it may cause trouble in water feed
owing to the drain water pressure.
Install the feed water pipe tube at a place free from heat.
Connect to potable water supply only.
Refer to instructions with water filter kit for installation.
This appliance contains fluid (refrigerant, lubricant)and is made of parts and
materials which are reusable and/or recyclable.
All the important materials should be sent to the collection center of waste
material and can be reused after rework (recycling). For take back, please contact
with the local agency.
Mount them in the reverse sequence of removal after they pass through the access
door.
Pass the
refrigerator
Before
installation
Warning
Disposal of the
old appliance
1
2
3
4
5
Max
FRZ
TEM
P
REF
TEM
P
Min
5
4
3
2
1
Max
Installation